Termite Control Can Also Be Done By Can Be Fun For Anyone
DO NOT waste bait by adding it to timbers which do not contain live termites. The colony is killed only if workers take enough of the bait back to the nest. And they will only take it whenever they can harvest it, undisturbed, from inside the damaged lumber you've found. .
See the uneven surface of the window frame. Termites had eaten it out, in certain areas leaving only the paint.
Termite Control Centurion Fundamentals Explained
Create an opening into the termites using a pointed knife or fine screwdriver. The hole should be no larger than about 5mm diameter to begin with. (It should be enlarged only when it is time to bring the cache of bait). You can pry into the surface of the wood where it feels spongy, thin or hollow.
It's only as a last resort you should attempt to open a tunnel on a wood or foundation surface. .
Once you have broken through into where it's hollow, wait for a minute or so. If termites are not there, the soldiers usually come to guard the opening while employees repair it. You will see their antennae and their heads blocking the gap. If no live termites appear, leave the gap open and return later or check next moment.
Get This Report on Termite Control Centurion
This shows how termites will come out from the infested timber into a foil covered mass of bait taped to the surface. Alternatively, if the surface is flat, the feeder might be repaired over the pit and the termites will enter it into harvest the bait.
If the wood has a level surface, make the hole from corners so that you can line it read this up with the hole in the base of the feeder. In case the access hole to the termites is on a round pole or another situation where you cannot repair the feeder to it, you can make a pouch of aluminium foil and duct tape to hold the bait in place.
If you're using the foil method, carefully pull the border of the tacky tape to inspect and to replenish the lure. If you're using the feeder method, it is not as disturbing if you can add more lure to the original feeder.
The termites you may see as dark brown nests high up in a tree are seldom pests of significance. Nevertheless, the main subterranean termites that do this 99% of the $damage we mentioned earlier, will often nest inside the central pipe or even hollowed out heart of a mature tree. Mastos, the giant northern termite, dont always wait for the decay of this pipe.
Getting The Termite Control Centurion To Work
(Watch the special box on Mastos).
If at colonising flight period a couple find their way into a hollow tree through possibly a dead/broken-off branch or in via a scar from flame at the bottom they could not possibly have better conditions. Theres plenty to eat, moisture and protection. A 50 metre travel to your residence would not be out of the question. .
If you have a large eucalypt, peppercorn or a mature fruit tree nearby, you should check it. Use an 15-20mm auger little long enough to drill into the centre of the trunk at approximately shoulder height. Drill at a slight downward angle and when you feel less resistance it will be because you achieve the pipe.
Excitement About Termite Control Can Also Be Done By
If not, you can slip in a long thin grass foliage into the drill hole, leave it there for a minute and draw it slowly. Termites might be found holding on, attacking it. If no live termites are found, return in half an hour or next morning; when there's termite life inside, they'll be repairing or have repaired the opening using their sand mixture. .
In this situation you dont need to see live termites; its just more satisfying to know you've murdered a colony when you take the next steps
Re-open the drill hole if it's been repairedUsing a funnel, plastic tubing and watering can/bucket, pour at least 20-30 litres of a chlorpyrifos or a bifenthrin solution down into the tree. These insecticidal concentrations can be purchased by a local hardware shop. They could be known by several brand names but the active ingredients are on the front panel of the tag.